Tm 100 Egg Incubator Without Turner (Manual Model); Assembly Of The Bellsouth - BellSouth 100 Instruction Manual

Assembly of the Bellsouth

without turner (Manual model)
Contents:
TM
i. A Bellsouth 100 egg incubator with view port (window) and thermostat
installed
ii. A thermometer and floor mounting bracket in a small box, in the bottom
(base) part of the polystyrene casing near the cast moulded water channels
iii. A perforated metal floor will be under the polystyrene casing (in the base of
the delivery box).
Assembly:
a. The bottom (base) part of the polystyrene casing contains the cast moulded water
channels and will need to be filled with water. If your ambient humidity is high,
use the smaller channel only and if ambient humidity is low, use the outer channel
only.
b. Carefully place the perforated metal floor into the bottom (base) part of the
polystyrene casing. The perforated metal floor has sharp edges - watch your
fingers!
Bayale Pty Ltd trading as Bellsouth
incubator.
ABN 54 895 116 137, CAN 154 912 839. Address: 5/22 Carter Way, Dandenong
100 egg incubator
TM
TM
manufacturer and supplier of Bellsouth
South VIC Australia.
7
TM
egg