Table of Contents
Advertisement
Assembly:
a.
The semi auto turner will be inside, the bottom part of the egg incubator
polystyrene casing. The plastic floor and plastic dividers will be fixed together
with cable ties for transit. Remove cable ties.
b.
The semi auto turner will sit on the perforated metal floor. The plastic
dividers will be assembled to a width slightly wider than the eggs you are
incubating, so they may turn.
c.
Place the assembled frame and perforated metal floor into the incubator
base.
d.
The thermometer is to be placed on the plastic dividers using the supplied
angle bracket and nuts & bolts.
e.
Ensure the curved end pieces are firmly attached onto frame.
f.
Ensure the plastic floor is located over the plastic rollers on each side of
frame.
g.
The plastic dividers located fit into the indents on side of frame. Space wide
enough for rows of eggs to roll.
h. Place the first plastic divider near the motor end. Place a row of eggs on the
tray and place a second plastic dividers in place. Ensure the plastic dividers
allow several millimetres clearance of the eggs. If the eggs touch both dividers
at the same time they will skid and not roll over. Too many eggs in each row
Bayale Pty Ltd trading as Bellsouth
incubator.
ABN 54 895 116 137, CAN 154 912 839. Address: 5/22 Carter Way, Dandenong
TM
manufacturer and supplier of Bellsouth
South VIC Australia.
12
TM
egg
Hide quick links:
Advertisement
Table of Contents
