BellSouth 100 Instruction Manual page 16

Assembly:
a. An Automatic turner will be inside, the bottom part of the egg incubator
polystyrene casing (if purchased). The plastic floor and plastic dividers will
be fixed together with cable ties for transit. An auto turner will have a plastic
bag with the electric automatic turner power pack and cord and flat U
shaped metal holder.
b. The auto turner will sit on perforated metal floor. The plastic dividers will
be assembled to a width slightly wider than the eggs you are incubating, so they
may turn. Ensure cable ties (for transit) are removed.
c. The thermometer is to be placed on a plastic divider. Place an egg on the tray
and place the thermometer on one of the plastic dividers using the bracket
in the accessory pack, in a place where the thermometer can be read through
the view port (window). Adjust the height of the thermometer bulb to sit
about 2mm above the top of the egg.
d. Ensure the curved end pieces are firmly slide onto frame.
e. Ensure the plastic floor is located over the plastic rollers on each side of
frame.
f. The plastic dividers slot into the indents on the side of the frame. Space
wide enough for rows of eggs to roll. For the auto turner slide the flat U
shaped metal clip over the end piece, with the bottom tongue under the
Bayale Pty Ltd trading as Bellsouth
incubator.
ABN 54 895 116 137, CAN 154 912 839. Address: 5/22 Carter Way, Dandenong
TM
manufacturer and supplier of Bellsouth
South VIC Australia.
15
TM
egg