Bissell POWERCLEAN 2494 SERIES User Manual page 9

Maintain the TurboEraser® Tool
1
Twist gray collar
counter-clockwise,
until slot appears,
then separate
faceplate.
Replace Brush & Belt
WARNING
To reduce the risk of electric shock, turn power switch OFF and disconnect polarized plug from electrical
outlet before performing maintenance or troubleshooting checks.
1
Unplug vacuum, turn over and unscrew
six (6) Phillips-head screws to remove
the bottom cover. Lift brush straight out.
3
Replace the Brush Roll and Belt by looping the Belt over the motor shaft and the
Brush Roll. Line up the end caps and pull the brush forward into place. This will
stretch the Belt. Return bottom cover back on and replace the screws.
2
Remove Brush Roll,
Belt, and Paddle
Wheel. Inspect
for damages and
replace if necessary.
Belt
End Cap
3
To reassemble, align two clips on each
end of paddle wheel with Belt on
and pop back into place. Place Brush
Roll with Belt back in. Faceplate will
not close properly if all parts are not
aligned correctly.
2
Clean debris from Brush Roll. Inspect by
placing on its end and spin. The Brush
Roll should spin freely, multiple times by
one flick. If it doesn't, replace Brush Roll.
Check Belt for wear or cuts and replace
if necessary.
www.BISSELL.com
9