Epson BrightLink 710Ui Installation Manual page 26

4. Determine the position of the wall plate's mounting holes.
Use at least four mounting holes.
Steps 5 to 9 below provide instructions for attaching the wall plate to a concrete wall.
5. Drill holes of the following diameters and depths.
Drill diameter
Pilot hole depth
Anchor hole depth
6. Remove the template sheet.
7. Use a device such as a dust pump to clean out concrete dust from the hole.
8. Position the wall plate on the wall and insert M10 × 60 mm expansion anchors into the holes. Attach
the nut and tap it with a hammer until the core touches the top of the anchor.
9. Tighten the nut with a wrench to secure the wall plate to the wall.
10. Remove the temporary wall plate screw.
0.41 in. (10.5 mm)
1.8 in. (45 mm)
1.6 in. (40 mm)
26