Daily Use - IKEA MATMASSIG Manual

ENGLISH

Daily use

Warning! Refer to Safety
chapters.
Ignition of the burner
Always ignite the burner before
you place the pots or pans.
To ignite the burner:
1. Push the control knob and turn it
anticlockwise to the maximum position
marked with .
2. Once lit keep the control knob pushed
for about 5 sec. As a result,
thermocouple heats up, and the safety
device switches off. If you do not push
the knob, the gas supply is interrupted.
3. When you light the flame, you can
adjust it.
If the burner does not ignite,
after a few attempts, check if the
crown and its cap are in correct
positions.
Burner cap
1
Burner crown
2
Injector
3
Thermocouple
4
Ignition candle
5
1
2
3
4
5
Turning the burner off
To put the flame out, turn the relevant
control knob to the symbol
Warning! Do not keep the
control knob pressed for more
than 15 seconds. If the burner
does not light after 15 seconds,
release the control knob, turn it
into the off position, and wait for
at least 1 minute before trying to
light the burner again.
If there is no spark when the
control knob is pushed then there
may be a fault with the power
supply. Refer to the
troubleshooting section.
Warning! Be careful when you
use open fire in the kitchen
environment. The manufacturer
declines any responsibility in
case of misusing the flame.
If the burner accidentally goes
out, turn the control knob to the
off position and wait for at least
1 minute before trying to light it
again.
When you switch on the mains
after installation or a power cut,
the spark generator activates
automatically.
The hob is supplied with the
progressive valves. They make
the flame regulation more
precise.
10
.