Power Cable - Shure UP4 User Manual

ENGLISH
1. After the mounting box is attached to the camera, insert the UP receiver in the box. It should slide in easily, but fit snuggly.
2. Connect XLR audio output on the bottom of UP receiver to audio input on the camera.
3. If not using internal 9V battery power, connect the DC jack on the bottom of the UP receiver to an external power supply (see Power Cable).
The supplied power cable consists of a locking DC power jack on one end and bare wires on the other. This is due to the wide variety of connectors
used by various camera manufacturers. In order to use the supplied power cable, you will first need to determine the appropriate connector for your
camera. Once you have obtained the correct connector, you will need to attach it to the supplied power cable. For further information about this
procedure, please contact Shure at 847/866–2200 and ask for the applications department. An AC power adaptor may also be used to power the
UP4 from a wall socket or other AC power supply.
INSTALLING THE UP4 RECEIVER
To Audio Input
To Power Supply
(if not using battery power)
FIGURE 23

POWER CABLE

– 11 –
ENGLISH
Side Mounted
Rear Mounted