Related Manuals for Shure WH30XLR
Summary of Contents for Shure WH30XLR
- Page 1 Models WH30TQG and WH30XLR User Guide MODEL WH30 CONDENSER HEADSET MICROPHONE WH30XLR ONLY 2003, Shure Incorporated Printed in U.S.A. 27D3121 (Rev. 4)
-
Page 2: Model Variations
WH30TQG: For wireless use, the WH30TQG has a 1.5m (5 ft.) high-flex cable • and a mini TA4F connector for direct connection to Shure body pack transmit- ters. (Note: for information about use with Shure W10BT or other transmitters without a mini TA4F connector, contact Shure Customer Service). -
Page 3: Wearing The Headset
You may position the elastic headband either above or below the wireframe for the greatest comfort and stability. The blue “SHURE” logo should face outward (see Figure 2). WH30 HEADSET MICROPHONE PARTS 1. Microphone Cartridge and Windscreen 2. -
Page 4: Adjusting The Headset
(see Figure 4B). Adjust the tension of the elastic headband across the back of the head by slid- • ing it up or down the ends of the wireframe (see Figure 5). FIGURE 4. POSITIONING THE FIGURE 3. MICROPHONE ADJUSTING THE WIREFRAME... -
Page 5: Positioning The Microphone
POSITIONING THE MICROPHONE For maximum gain-before-feedback, position the microphone and boom so that the microphone is within 13 mm (1/2 inch) of the right corner of your mouth (see Figure 3). This will also help minimize breath noise or “popping”. -
Page 6: Replacement Parts
CERTIFICATION The WH30XLR conforms to European EMC Directive 89/336/EEC, and is eligible to bear the CE marking. Meets applicable tests and performance criteria in European standard EN 55103 (1996) parts 1 and 2, for residential (E1) and light industrial (E2) environments. The WH30TQG conforms to European EMC Directive 89/33/EEC, and is eligible to bear the CE marking. -
Page 7: Specifications
... . . 0 to 95 % (operating or storage) 3.05 m (10 ft.) two-conductor, shielded mini TA4F Headset: 65 g (2.3 oz) WH30XLR Condenser, electret bias with integrated preamplifier Rated 150 Ω (actual) (Tolerates loads as low as 150 Ω with reduced clipping level) –54.5 dB (1.9 mV) - Page 8 1 cm. (0.4 in.) 61 cm. (24 in.) FREQUENCY IN Hz FIGURE 6. WH30: TYPICAL FREQUENCY RESPONSE WH30: TYPICAL POLAR PATTERNS FIGURE 7.
-
Page 9: Wiring Diagrams
WIRING DIAGRAMS CARTRIDGE ELEMENT CARTRIDGE ELEMENT FILTER MODEL WH30TQG RED (to drain) (DC bias) BLACK (to source) (audio) FILTER SHIELD MODEL WH30XLR BLACK (to source) (audio) RED (to drain) (DC bias) PREAMP SHIELD WIRING DIAGRAMS FIGURE 8. TA4F CONNECTOR XLR CONNECTOR... - Page 10 Trademark Notices: The stylized Shure logo and the word “Shure” are registered trademarks of Shure Incorporated in the United States. “Teflon” is a registered trademark of E.I. duPont de Nemours and Company in the United States. “Croakies” is a registered trademark of Life-Link International, Inc.