Assembling.the.blower - Shindaiwa 68907-94311 Owner's/Operator's Manual

Assembling the Blower
Push the blower tube
over the discharge port
and locking pin
Locking Pin
Blower
1
Tube
Rotate clockwise to lock
2
Place.the.blower.upright.on.the.ground.or.
on.a.sturdy.work.surface.
1.. Grasp.the.blower.tube.as.shown,.and.
push.the.tube.over.the.blower.discharge.
port.and.locking.pins.
.. Lock.the.blower.tube.to.the.blower.
discharge.port.by.rotating.the.tube.as.
shown.
6
Push the nozzle
Blower Tube
over the blower
tube and locking
Locking Pin
3
Nozzle
Rotate clockwise to lock
Mark
"THIS SIDE UP"
must face up
4
3.. Grasp.the.nozzle.with.the.mark."THIS.
SIDE.UP".positioned.as.shown,.and.
then.push.the.nozzle.over.the.straight.
tube.and.locking.pins.
4.. Lock.the.nozzle.to.the.straight.tube.by.
rotating.the.nozzle.as.shown.
Blower tube installation affects both blow-
er balance and performance! The tube
and nozzle are correctly installed when
the mark "THIS SIDE UP" is visible to the
pin
operator during normal operation.
Danger from rotating impeller!
Stop the engine before installing or
removing the blower tubes! Never
perform any maintenance or assembly
procedures on this unit while the
engine is running!
IMPORTANT!
WARNING!