Sherwood RX-4103 Operating Instructions Manual page 11

Adjusting the tone(bass and treble)
Enter the tone mode.
8
POWER
1
5
9
TONE
DISPLAY
CD
AUDIO CONTROL
or BALANCE
REMOTE CONTROL UNIT RM-101
Each time this button is pressed, the corresponding
tone mode is selected and shown for 5 seconds as
follows:
BAS(s) TRE(ble)
Note:
When the tone direct function is activated, the tone
mode cannot be entered and "T-DIR" is displayed.
To listen to a program source without the tone effect.
10
TONE DIRECT
Adjusting the sound volume balance
Enter the balance mode.
11
BALANCE
"BAL" is displayed for 5 seconds.
A SPEAKER B
2 3 4
6 7 8
0
FM MODE MEMORY
SLEEP P.SCAN TUNER
TAPE VCR AUX
TONE SEL
TONE SEL
TREBLE
MUTE VOLUME
/BASS
11
At the desired tone mode, adjust the tone as
9
desired.
or
If the tone display disappears, start from the step 8
again.
Notes:
Extreme settings at high volume may damage your
speakers.
In general, the bass and treble levels are adjusted
to 0.
"T-DIR" is displayed and the sound that bypasses
the tone circuitry will be heard.
To cancel the tone direct function, press this button
again to display "D-OFF".
Adjust the sound volume balance between
12
the left and right speakers.
or
If the balance display disappears, start from the
step 11 again.
When the BALANCE + / - buttons on the remote
control are pressed, it enters the balance mode
automatically without pressing the BALANCE
button on the front panel.
Note:
In general, the balance level is set to the center
position(red dot).
POWER A SPEAKER B
1 2 3 4
5 6 7 8
9 0 FM MODE MEMORY
DISPLAY SLEEP P.SCAN TUNER
CD TAPE VCR AUX
TONE SEL
AUDIO CONTROL
TREBLE
TREBLE
BALANCE /BASS MUTE VOLUME
/BASS
REMOTE CONTROL UNIT RM-101
POWER A SPEAKER B
1 2 3 4
5 6 7 8
9 0 FM MODE MEMORY
DISPLAY SLEEP P.SCAN TUNER
CD TAPE VCR AUX
AUDIO CONTROL TONE SEL
TREBLE
BALANCE BALANCE /BASS MUTE VOLUME
REMOTE CONTROL UNIT RM-101