Room2 Playback - Sherwood RX-773 Operating Instructions Manual

ROOM2 PLAYBACK

• This function allows enjoying one source in the main room and playing another in a different room at the same time.
• Even when this receiver enters the standby mode, in such a case that "R2" is dimly lit, meaning only the ROOM2 circuitry
operates, the ROOM2 source can be played independently. Therefore, when you do not use the ROOM2 function, turn off the
ROOM2 function to save electricity.
• To enjoy ROOM2 source, turn on the ROOM2 function and adjust the ROOM2 settings as below.
1.
Enter the ROOM2 mode.
or
• "R2 > ~ " is displayed for several seconds.
• Each time this button is pressed, the mode is changed to
the ROOM2 mode ("R2 > ~") or the main mode (main
input display).
• When "R2 > ~" is not displayed, press this button again.
■Note : Only while displaying the ROOM2 mode, you can
set the ROOM2 mode.
2.
Turn on the ROOM2 mode.
or
• Each time the POWER ON/STANDBY button on the front
panel is pressed, the ROOM2 mode changes as follows :
R2 > OFF : ROOM2 off mode("R2" turns off)
R2 > input display : ROOM2 on mode("R2" lights up)
• On the remote control, press the POWER ON button to
turn on the ROOM2 mode or press the STANDBY button
to turn it off.
■Note : Only while displaying the ROOM2 on mode, you
can adjust the ROOM2 settings.
3.
Select the desired ROOM2 speakers.
or
• Each time the SPEAKER C/D SELECTOR button is
pressed, the speakers are switched on or off as
follows:
R2 C/D R2 - / -
■Note : Only when the ROOM2 mode is set to on, the
speakers C or/and D can be used as ROOM2
speakers.
4.
Select the desired ROOM2 input.
or
• Each time the INPUT SELECTOR knob is rotated, the
ROOM2 input source is changed as follows :
TUNER PHONO
BT-IN CD
24
R2 C/ - R2 - /D
AUX 2 AUX 1
TAPE DVD AUX