Recording - Sherwood DS-801 Operating Instructions Manual

RECORDING

Load a tape to be recorded.
1
OPEN/CLOSE
• Be sure the erase-protection tabs on the tape are in
place.
• The type of tape(normal or chrome) is automatically
detected.
• The metal tapes are not recorded correctly.
When recording with Dolby B NR
system, select the Dolby B NR mode.
2
SLEEP POWER
AUX
1 2 3
MD
4 5 6
DOLBY
TUNER
7 8 9
CD TAPE
0
DOLBY C.RESET CD SYNC. REV.MODE
EDIT TIME REPEAT RANDOM
EON RDS
AUTO/MONO TUNING TUNE MODE
PROGRAM
MEMO ENTER
VOL
VOL
MUTE TIMER DISPLAY
REMOTE CONTROL UNIT
RM-404
• "B" lights up.
Select the program source to be recorded.
Example) When selecting the tuner.
4
SLEEP
1 2
4 5
7 8
0
FUNCTION DOLBY C.RESET
EDIT TIME
AUTO/MONO TUNING
or PROGRAM
MEMO
MUTE
REMOTE CONTROL UNIT
RM-404
SYSTEM REMOTE
CONTROL UNIT
(only for RX-801R)
POWER
AUX
TUNER
3
MD
6
TUNER
9
CD TAPE
CD SYNC. REV.MODE
REPEAT RANDOM
EON RDS
TUNE MODE
ENTER
VOL
VOL
TIMER DISPLAY
SYSTEM REMOTE
CONTROL UNIT
(only for RX-801R)
1 1
Note
• When there is a erase-protection tab, to record on a
single side, you should load a tape correctly or select
the corresponding tape direction depending on the
tape direction display( : Playback/recording of the
back side, :Playback/recoding of the front side).
• For your reference, when loading a tape, the side
facing up is the front side and the erase-protection
tabs of the corresponding sides are as follows:
Erase-protection tab of the front side
Front side
Erase-protection tab of the back side
Select the reverse mode.
3
POWER
SLEEP
AUX
1 2 3
MD
4 5 6
TUNER
7 8 9
CD TAPE
0
DOLBY C.RESET CD SYNC. REV.MODE
EDIT TIME REPEAT RANDOM
EON RDS
AUTO/MONO TUNING TUNE MODE
PROGRAM
MEMO ENTER
VOL
VOL
MUTE TIMER DISPLAY
REMOTE CONTROL UNIT SYSTEM REMOTE
RM-404
CONTROL UNIT
(only for RX-801R)
• According to the selected reverse mode, recording
will be performed as follows:
: Recording of a single side.
, : Recording of both sides.
• When selecting the recording of both sides and
recording first on the back side, recording is made
only on that side.
• Be sure the both of erase-protection tabs on the tape
are in place when recording on the both sides.
Press the RECORD/RECORD MUTE
button to enter the recording pause mode.
5
• " " lights up and this unit enters the recording
pause mode.
• In the recording pause mode, when this button is
pressed, the unit will make a 4 second blank space
and then enter the recording pause mode.
REV.MODE