Loading Batteries; Filling Fuel Tank With Fuel - CORONA SX-2E Owner's Manual

3. Loading batteries
The battery case is placed at the back of the heater cabinet. Put
two batteries in the battery case according to the ( +) and (-)
polar,ity marks.
FILLING FUEL TANK WITH FUEL
A WARNING:
USE ONLY WATER CLEAR N0.1-K KEROSENE (ASTM 1-K) OR SYNTHETIC FUELS FOR
USE WITH KEROSENE-FIRED PORTABLE HEATERS. THE USE OF ANY SUBSTANCE
OTHER THAN KEROSENE OR SYNTHETIC FUELS COULD RESULT IN AN EXPLOSION
OR ARE.
A WARNING:
NEVER ALL HEATER FUEL TANK IN LIVING SPACE. ALL HEATER TANK
OUTDOORS.
TURN THE HEATER "OFF" BEFORE REMOVING THE FUEL TANK FOR REALUNG.
1. Open the fuel tank access door and take out the cartridge tank.
2. Place the cartridge tank out of harm' s way in the open with the fuel feeding cap upside.
3. Detach the fuel feeding cap by turning it counterclock-wise.
4. Fill the cartridge tank with fuel using the siphon pump, which is placed in the carton, according to the
following procedure:
1) Put the straight tube into the fuel container and the flexible tube into the cartridge tank.
2) Tighten the valve cap on the top of the grip (see illustration below).
3) Squeeze the grip to let fuel flow into the cartridge tank.
4) When fuel is filled almost to the middle point of the fuel gauge, loosen the valve cap of the grip
and then the fuel flow will come to a stop.
0 )(
@ @
rr
GOOD OVER-FILLED
Note: When the fuel gauge turns black halfway up, it indicates that the cartridge tank is filled with
right amount of fuel. Do not fill beyond this level.
5. Replace the fuel feeding cap on the tank and tighten it. Clean up all fuel spills.
6. Put the cartridge tank back in the heater.
- 5 -