CORONA SX-2E Owner's Manual page 12

4) Unfasten the three nuts that hold the wick guide in place. Remove the wick guide by pulling
it up.
Nuts
5) Pull the wick ra1 smg the support bracket to the right and remove the wick and the wick holder
from the wick guide tube.
6) Detach the old wick from the wick holder and fit a new one in it.
To attach the wick
a. Adjust the gap of the wick to fit in the wick raising bracket of the wick holder.
Wick
Wick holder
~Gap
Wick raising bracket
Fittings
~
Recesses
Note: The misalignment of the wick gap with the wick raising bracket may result in damage to
the glow plug or its failure to function.
b. Put the wick f ittings (three) into the recesses (three) in the wick holder.
Wick raising
bracket
f,XXW{' f M :::::::::=--
Bring both into
alignment with each other
c. Press the wick against the wick holder catches letting it stick on the catches making it fit
evenly in the inner wall of the holder. Use care not to develop wrinkles and bulges.
- 11 -