Operating; General Safety Precautions - Husqvarna PG400 Operator's Manual

General safety precautions

WARNING! This section describes basic
!
safety directions for using the machine.
This information is never a substitute for
professional skills and experience. If you
get into a situation where you feel unsafe,
stop and seek expert advice. Contact your
dealer, service agent or an experienced
user. Do not attempt any task that you feel
unsure of!
• Do not use the machine without first reading and
understanding the contents of this Operator's Manual.
Save all warnings and instructions for future
reference.
Work area safety
• Keep work area clean and well lit. Cluttered or dark
areas invite accidents.
• The machine should not be used in areas where
potential for fire or explosions exist.
Electrical safety
WARNING! There is always a risk of shocks
!
from electrically powered machines. Avoid
unfavourable weather conditions and body
contact with lightning conductors and
metal objects. Always follow the
instructions in the Operator's manual to
avoid damage.
Never connect the machine to a outlet if
plug or cord is damaged.
CAUTION! The equipment fulfills the
!
requirements in EN61000-3-11 and is
subject for conditional connection to the
mains. It may be connected in consultation
with the supply authority.
The equipment will only be connected to
the mains supply with impedance lower
than 0,39 ohm, applies only to 3-phase. The
system impedance at the interface point
may be obtained from the supply authority.
If the mains supply has higher system
impedance, short voltage dips may appear
when the equipment is started. This may
influence the operation of other products,
e.g flickering lights.
• Check that the mains voltage corresponds with that
stated on the rating plate on the machine.
• Inspection and/or maintenance should be carried out
with the motor switched off and the plug disconnected.
• Always shut down the machine before disconnecting
the power plug.
• Never drag the machine by means of the cord and
never pull out the plug by pulling the cord. Hold the
plug to disconnect the power cord.

OPERATING

• Never use the machine if any cable or plug is
damaged, but hand it in to an authorized service
workshop for repair.
• The machine must never be driven to such a depth in
water that it reaches up to the machine's equipment.
The equipment can be damaged and the machine can
be live, resulting in personal injuries.
• Always have the power cable disconnected when
connecting and disconnecting the contact between
the motor and the electrical box.
Grounding instructions
!
• The machine is equipped with a grounded cord and
plug and should always be connected to a grounded
outlet. This reduces the risk of electric shock in the
event of malfunction.
• The use of adaptors is not allowed with the machine.
Extension cords and cables
• The marking on the extension cable must be the same
or higher than the value stated on the machine's rating
plate.
• Use grounded extension cables.
• When operating a power tool outdoors, use an
extension cord suitable for outdoor use. Use of a
cord suitable for outdoor use reduces the risk of
electric shock.
• Keep the connection to the extension cord dry and off
the ground.
• Keep cable away from heat, oil, sharp edges or
moving parts. Damaged or entangled cable increase
the risk of electric shock.
• Check that the cables are intact and in good condition.
Never use the machine if any cable is damaged, but
hand it in to an authorized service workshop for repair.
• To avoid overheating do not use the extension cord
while it is rolled up.
• Ensure the cord is behind you when you start to use
the machine so that the cord will not be damaged.
• When using an extension cable, use only certified
extension cables with sufficient reach.
WARNING! Improper connection can
result in the risk of electric shock.
Contact a qualified electrician if in doubt
as to whether the appliance is properly
grounded.
Do not modify the plug. If it will not fit the
outlet have a proper outlet installed by a
qualified electrician. Make sure local
regulations and ordinances are followed.
If the grounding instructions are not fully
understood contact a qualified
electrician.
–
English 7