Frame Height Adjustment - Husqvarna PG400 Operator's Manual

Frame height adjustment

The angle of the frame can be adjusted to alter the weight
distribution of the chassis to decrease or increase
grinding pressure. It can also be used to allow a more
comfortable working position for different operators.
• Disconnect the motor cable from the electrical box.
• Standing beside the grinder, squeeze the handle on
the central hinge while simultaneously angling the
upper frame to the inclined transport position.
• Loosen the nuts a few turns to release any pressure.
• Pull out the locking pins and remove the bolts on each
side of the grinding head.
• Remove the wheel chassis from the grinding head.
10 – English
OPERATING
1
3
2
• Standing beside the wheel chassis, squeeze the
handle on the central hinge while simultaneously
angling the upper frame forward to the lifting position.
• Loosen the locking knobs on the support foot.
• Hold the handlebar to stabilize the frame and lift out
and up the support foot.
• Choose the appropriate position required by
tightening up the locking knobs in the correct hole.
The lower hole for a higher handlebar and greater
grinding pressure. The upper hole for a lower handlebar
and less grinding pressure.