Creating A Profile - Saeco PicoBaristo Deluxe User Manual

Creating a profile

1 Tap the Profiles icon repeatedly to select one of the profiles. All profiles have different colors.
You can also use the up and down icons to select your profile.
2 Tap the OK icon to customize the profile.
3 Use the up and down arrows to select the drink you want to customize and tap the OK icon to
confirm.
4 Use the up and down arrows to adjust the settings to your preference and tap the OK icon to
confirm. Customized drinks are marked with an asterisk (*) (Fig. 13).
Adjusting grinder settings
You can adjust the grinder settings by using the grind setting knob inside the bean container. There
are 12 different grind settings you can choose from. The lower the setting, the stronger the coffee.
Note: You can only adjust the grind settings when the machine is grinding coffee beans. You need to
brew 2 to 3 drinks before you can taste the full difference.
Caution: Do not turn the grind setting knob more than one notch at a time to prevent damage to the
grinder.
1 Place a cup under the coffee dispensing spout.
2 Open the lid of the bean hopper.
3 Tap the ESPRESSO icon. Then press the start/stop
4 When the grinder starts grinding, press down the grind setting knob and turn it to the left or right
(Fig. 14).
Handling the brew group
Go to www.saeco.com/care for detailed video instructions on how to remove, insert and clean the
brew group.
Removing the brew group from the machine
1 To switch off the machine, first press the on/off button on the control panel and then set the main
switch on the back of the machine to 'O'.
2 Remove the drip tray with the coffee grounds container.
3 Open the service door (Fig. 15).
4 Press the PUSH button (1) and pull at the grip of the brew group to remove it from the machine (2)
(Fig. 16).
5 Remove the coffee residues drawer (Fig. 17).
Reinserting the brew group
Before you slide the brew group back into the machine, make sure it is in the correct position.
1 Check if the arrow on the yellow cylinder on the side of the brew group is aligned with the black
arrow and N (Fig. 18).
-
If they are not aligned, push down the lever until it is in contact with the base of the brew group
(Fig. 19).
2 Make sure that the yellow locking hook on the other side of the brew group is in the correct
position.
button.
English
11