Using Your Water Optimizer
N
on the
Dispense
dispense until button is released, or 10 minutes has elapsed.
Mode, when triggered, will dispense water for 10 seconds (this time is
QuickFill
customizable, see
It is active by default, and can be toggled by pressing
To dispense water using QuickFill Mode (when active), simply press the
Dispense
Button.
Mode, when triggered, will continuously dispense water 'hands-free'
ConstantFill
until it is disengaged (or 90 seconds has elapsed). It can be toggled by pressing
M
the
QuickFill Mode Button
indicating ConstantFill Mode is active. Once it has been selected, simply press the
Dispense Button
Customizing QuickFill Mode
QuickFill Mode
can be customized to fit your favorite cup, bottle, or other container. Be
aware that this function is controlled by a timer, and may vary based on fluctuations in your
water sources pressure (i.e. when your sink is running if that is your source). Complete the
following instructions to customize the time. Minimum required duration of 6 seconds.
1. Place your desired container (empty) underneath the
2. Press and hold the
3. Press and release the
4. Once your container has reached the desired fill level, press and release the
Dispense Button
5. Finally, press and release the
You're all set!
Controlling Dispenser Light
Your Water Optimizer is equipped with a
Using Your Water Optimizer 10
Button. Water (of selected temperature mode) will continue to
"Customizing QuickFill Mode" on page
once, after which the button's light will shutoff,
to start dispensing water, and then press it again to stop dispensing.
M
QuickFill Mode Button
N
Dispense
to stop water from dispensing.
M
QuickFill Mode Button
M
O
for 5 seconds. Button begin to flash.
Button. Water will begin dispensing.
II
Dispenser
Light. It has 3 different modes
10), and then stop.
QuickFill Mode
Button.
N
Water Dispenser
to save your new fill time.
N
Nozzle.
N