Stack Projection
Setting up the Stack Projection
Basic
This part shows an example for setting up the stack projection of a computer image with two projectors.
COMPUTER/COMPONENT1 terminal
Projector 1: Master
MONITOR OUT (FOR COMPUTER/
COMPONENT1, 2) terminal
COMPUTER/COMPONENT1 terminal
Projector 2: Slave
1
Set the "Stack Setting" of the pro-
jector 1 to "Master".
(See page 62 on the projector operation
manual.)
2
Set the "Stack Setting" of the pro-
jector 2 to "Slave".
(See page 62 on the projector operation
manual.)
3
Perform "Pair Stack" of the both
projectors.
(See page 63 on the projector operation
manual.)
-42
RGB
cable
4
5
RGB cable
LAN terminal
LAN cable
(cross-over type)
LAN terminal
Select inputs as specified in the
table below.
(See page 63 on the projector operation
manual.)
Projector 1
Master
Set Inputs
COMPUTER1
ON
COMPUTER2
OFF
DVI
OFF
HDMI
OFF
VIDEO
OFF
S-VIDEO
OFF
Turn off the both projectors.
Computer
Projector 2
Slave
Set Inputs
COMPUTER1
ON
COMPUTER2
OFF
DVI
OFF
HDMI
OFF
VIDEO
OFF
S-VIDEO
OFF