Unpacking And Installation; Installing Procedure Flowchart - Sharp AR-M350N/M450N Service Manual

[6] UNPACKING AND INSTALLATION

1. Installing procedure flowchart

There are many combinations between this machine and option units. For installing option units, observe the following procedures for efficiency.
To install the devices efficiently, follow the procedure below.
Some peripheral devices may have been installed as standard devices depending on the main unit model.
Part of descriptions and illustrations may be different.
Scanner/document feeder device
Finishing device
Duplex device
Start of installation
Main unit, paper feeding
device, and power supply
unit.
AR-D13 /AR-DC1
AR-D14 /AR-DC1
Main unit
Yes
Duplex/bypass
device installed?
No
Yes
Finishing device
installed?
No
Yes
Scanner/document
feeder installed?
No
* When installing an option, refer to the Service Manual for that option and or the AR-M350 / M450 Service Manual.
Main unit
Paper feeding device
Install duplex/pypass device.
AR-DU3
AR-DU4
Install finishing device.
AR-MS1/AR-DC1
AR-FN6 /AR-DC1
AR-FN7
AR-PN1A / B / C / D
Install scanner/document feeder.
* AR-EF1 /AR-RK1
AR-M350U UNPACKING AND INSTALLATION 6-1
Scanner/document feeder device
Duplex/bypass device
Finishing device
Controller board,
facsimile unit or other
electric devices
installed?
No
[Electrical setting/adjustment]
1) Installation of driver software, setting,
and operation check
Main unit/AR-EF1/AR-NC5J/AR-HD3/
AR-FX5/AR-PK1/AR-NS2/AR-P14
2) Paper guide position adjustment/off center adjustment
AR-D13/AR-D14/
AR-DU3/AR-DU4
End
When installing a paper feeding device, an optional power supply unit or a duplex/bypass device, be
sure to re-attach the rear cabinet, the AC inlet cover, and the harness cover of the main unit at the
end of installation as needed.
When installing a controller board, a facsimile unit, and other electric devices, be sure to install them
one at a time.
Only off center adjustment is needed for AR-DU3.
Finishing device
Main unit
Paper feeding device
Install controller board,
facsimile unit or other electric
devices.
AR-HD3
AR-FX5/AR-MM9
Yes
AR-PK1
AR-NS2
AR-NC5J
(Not required for the AR-M350N/M450N)
AR-P14
(Only AR-M350U/M450U)
Extended memory