Bunker Hill Security 61624 Owner's Manual & Safety Instructions page 11

E. Mount Cameras
CONNECT AND TEST ALL EQUIPMENT AND CAMERA LOCATIONS
BEFORE MOUNTING CAMERAS.
Mount Cameras under eaves. Place
Cable Connections inside walls to shelter
them from rain and direct sunlight.
Using the Base as a template, mark locations
of mounting holes on mounting surface.
Note: Route Cable through slot on Base to keep Base
flush with mounting surface while marking holes.
Solid Surface
1. Using a drill bit slightly smaller than the Screws,
drill pilot holes into the marked locations.
2. Position Camera so that mounting
holes align with pilot holes.
Hollow Surface
1. Using a drill bit slightly smaller than the
Anchors, drill holes in the marked locations.
2. Tap Anchors into the holes until they are
almost flush with mounting surface.
3. Position Camera so that mounting
holes align with anchors.
Camera Adjustment
1. Loosen Adjustment Wheel, rotate Camera as
needed, then tighten Adjustment Wheel.
2. Loosen Adjustment Screw, tilt Camera as
needed, then tighten Adjustment Screw.
Note: Only loosen Adjustment Screw
slightly, do not remove it.
F. Set Date and Time
Note: Use Mouse to navigate the DVR.
1. Right click on screen,
click System Setup.
2. Click Time.
Item 61624
3. Put cursor in Date box,
click keys to set date.
For technical questions, please call 1-888-866-5797.
Cable
Slot
Note: Route Cable through slot on Base to
keep Base flush with mounting surface.
3. Drive Screws through mounting holes in
Base and into pilot holes until the Camera is
securely attached to the mounting surface.
Note: Route Cable through slot on Base to
keep Base flush with mounting surface.
4. Drive Screws through mounting holes in
Base and into anchors until the Camera is
securely attached to the mounting surface.
Adjustment
Wheel
Adjustment
Screw
4. Put cursor in Time box,
click keys to set time.
Mounting
Holes
Base
5. Click OK.
Page 11