Table of Contents
Advertisement
To Attach The Electrode Handle:
1.
WARNING! Make sure to connect the Electrode Holder (27) to the
Electrode Cable only. (See Figures E and G.)
2.
Slide the Handle Grip off the Electrode Holder (27). (See Figure G.)
3.
Insert the Electrode Cable through the Handle Grip. (See Figure G.)
4.
Place the bare end of the Electrode Cable into the open end of the Electrode
Holder (27). Secure the Electrode Cable to the Electrode Handle by tightening
the Screw onto the end of the Electrode Cable. (See Figure G.)
5.
With the Electrode Cable secured to the Electrode Holder (27), slide the
Handle Grip over the Cable/Handle connection. Tighten the Handle Grip
securely in place by tightening the Screw at the base of the Handle Grip.
(See Figure G.)
6.
NOTE: The Welder produces powerful electrical currents. It is critical that
you remain insulated from this current. Never use the Welder if any of the
insulating Handle Grips are not in good repair. (See Figure G.)
SCREWDRIVER
(NOT INCLUDED)
ELECTRODE
HANDLE
(27)
HANDLE GRIP
SKU 55594
For technical questions, please call 1-800-444-3353.
SCREW
ELECTRODE
CABLE
FIGURE G
SCREW
Page 14
Hide quick links:
Advertisement
Table of Contents
