Indoor Unit Connections - LG ART COOL LA090HSV5 Installation Manual

REFRIGERANT PIPING CONNECTIONS
Indoor Unit Connections for HSV5 Units
Removing the Indoor Unit Bottom Cover
To access the indoor unit piping port connections, and
to make the indoor unit installation procedure easier,
it is recommended that the bottom cover be removed
first.
1. Unsnap the bottom cover at its top left and right
sides (Location 1).
2. Unsnap each of the three (3) or four (4) small
C-hooks located in the middle of the bottom cover
(Location 2). Number of C-hooks present depends
on model of indoor unit.
3. Lift the three (3) to four (4) hinges on the bottom
cover up and out of the channels molded to the
left, right, and middle of the indoor unit (Location
3). Number of hinges present depends on model
of indoor unit.
4. Set aside the bottom cover to re-install after all
procedures are complete.
Accessing and Positioning the Indoor Unit Piping / Connections
1. Unsnap the piping / drain hose holder (L-bracket) out from the indoor unit chassis. Prop it open between the indoor unit chassis and
installation plate to separate the bottom of the indoor unit from the wall. This will allow for more working space.
Figure 41: Propping Open the Piping / Drain Hose Holder (L-bracket).
Piping / Drain Hose Holder
2. Remove the piping port cover.
3. Position the piping by unfolding and bending the piping slowly
downward first as shown, then to the left or right (pre-chosen
following installation guidelines and application needs) as shown.
Secure piping with the piping holder.
36
Figure 44: Removing the Bottom Cover.
3
Due to our policy of continuous product innovation, some specifications may change without notification.
©LG Electronics U.S.A., Inc., Englewood Cliffs, NJ. All rights reserved. "LG" is a registered trademark of LG Corp.
Figure 45: Removing the Bottom Cover,
Alternate View.
3
3
Figure 42: Back of Indoor Unit.
Piping / Drain Hose Holder
Right Side
Piping
Figure 43: Bending Piping at Rear of Indoor Unit.
Unfold
slowly
downward
Left Side Piping
Rear
Piping
Bend from
downward position