Preparation; Installing Batteries In The Remote Control; Using The Remote Control - Sharp Aquos LC-20B8U Operation Manual

Preparation

Before using the LCD TV set for the first time, install the two "AAA" size batteries supplied in the remote control. When the
batteries become depleted and the remote control fails to operate, replace the batteries with new "AAA" size batteries.
1
Open the battery cover.
■ Slide the cover while
pressing the ( ) part.
Caution!
Precautions regarding batteries
■ Improper use of batteries can result in a leakage of chemicals and/or explosion. Be sure to follow the instructions below.
• Place batteries with their terminals corresponding to the (+) and (–) indications.
• Different types of batteries have different characteristics. Do not mix batteries of different types.
• Do not mix old and new batteries. Mixing old and new batteries can shorten the life of new batteries and/or cause old
batteries to leak chemicals.
• Remove batteries as soon as they are depleted. Chemicals that leak from batteries can cause a rash. If chemical
leakage is found, wipe it off with a cloth.
• The batteries supplied with the LCD TV set may have a shorter operating time due to storage conditions.
• If the remote control is not to be used for a long period of time, remove the batteries from the remote control.
■ Use the remote control by pointing it towards the remote sensor
window of the main unit. Objects between the remote control and
sensor window may prevent proper operation.
Cautions regarding use of the remote control
■ Do not apply shock to the remote control. In addition, do not
expose the remote control to liquids, and do not place it in an area
with high humidity.
■ Do not install or place the remote control in direct sunlight. The
heat may cause deformation of the unit.
■ The remote control may not work properly if the remote sensor
window is in direct sunlight or strong lighting. In such a case,
change the angle of the lighting or main unit, or operate the
remote control closer to the remote sensor window.

Installing Batteries in the Remote Control

2
Insert two "AAA" size batteries.
■ Place batteries with their
terminals corresponding
to the (+) and (–)
indications in the battery
compartment.

Using the Remote Control

3
Close the battery cover.
■ Engaging the lower
claw with the remote
control, close the
cover.
Headphone jack
OPC indicator
POWER/WAKE UP TIMER
indicator
Remote sensor
OPC sensor
7