Table of Contents
Advertisement
7.
To avoid electrical shock, do not handle the Charger (part #38), its Power
Cord Plug, or the Cordless Shear with wet hands.
8.
Keep the Handle of the Cordless Shear dry, clean, free from oil and
grease.
9.
Avoid unintentional starting. Make sure you are prepared to begin work
before turning on the Cordless Shear.
10.
Never leave the Charger (part #38) unattended when it is plugged into an
electrical outlet. Make sure to unplug it from its electrical outlet before leaving.
11.
Always turn off the Cordless Shear and unplug the Charger (part #38) from
its electrical outlet before changing accessories or performing any inspec-
tion, maintenance, or cleaning procedures.
12.
PROPER BATTERY PACK CARE: Battery Pack (part #36) leakage may occur
under extreme usage or temperature conditions. If Battery Pack fluid comes in
contact with skin, wash with soap and water and rinse with lemon juice and
vinegar. If the fluid comes into contact with the eyes, flush with water for several
minutes and contact a doctor immediately. Never burn the Battery Pack, as it can
explode in a fire. Do not charge the Cordless Shear with a leaking Battery Pack.
Contact local solid waste authorities for instructions on correct disposal or
recycling of the Battery Pack.
Note: Always switch to a fresh battery when tool performance begins to
diminish. Severe heat is most destructive to a battery; the more heat
generated, the faster the battery loses power. A battery that gets too hot can be
permanently damaged. Never over-discharge a battery by using the tool even
after tool performance is decreasing. Never attempt to discharge a tool's battery
by continuing to pull the tool trigger. When tool performance begins to
diminish, stop the tool, re-charge the battery and use the fresh battery for
optimal performance.
13.
Use eye and hearing protection. Always wear ANSI approved safety impact
eye goggles and hearing protectors when using this product.
14.
Do not allow children to use or play with this product.
15.
Keep hands and fingers away from the Blades (parts #4, #5, #6) at all times.
If both hands are holding the Cordless Shear by its Handle (parts #2, #34), they
cannot be cut by the Blades.
16.
Feed the Cordless Shear gradually into the workpiece. Do not attempt to
force the Shear to remove material faster than it was designed to cut.
17.
Secure the workpiece. Whenever possible, secure the workpiece with a vise or
clamps (not included).
SKU 90541
PAGE 6
Advertisement
Table of Contents
