Advertisement
6
PRE-ARRANGED JUMPER HARNESS CONNECTIONS
1. Locate and release the vehicle's 8-pin and 2-pin pre-fi t
connectors secured to the vehicle's wire harness with
breakaway tape near the upper passenger's side glove
box area. (FIGURE J)
2. When the vehicle's 8-pin and 2-pin pre-fi t connectors
are free from the breakaway tape, unplug and discard
the 2-pin mating connector/wire jumper. (This is used
for the power window interrupt circuit).
3. Plug the remote engine start pre-arranged jumper
harness 8-pin and 2-pin connectors into the
corresponding pre-fi t connectors. (FIGURE K)
4. Secure the pre-arranged jumper harness to the vehicle's
wire harness using three (3) of the supplied 20cm tie
wraps. Trim off the excess tie wraps. (FIGURE L)
5. Plug the pre-arranged jumper harness 12-pin connector
into the 12-pin white port on the remote engine start
ECU, previously mounted to the back side of the glove
box inner cover (Step 5).
ISSUE
PART NUMBER
H001SFL300
DATE
00
22 Jun 2018
FIGURE J
FIGURE K
FIGURE L
SUBARU OF AMERICA
4 OF 7
Advertisement
