Learning Remote Control Function - Sharp Aquos LC 37HV4U Operation Manual

Other viewing options

Learning remote control function

You can operate the connected AV products (AV
Receiver, Cable Box, SAT tuner, DTV, VCR, DVD, LD)
using the learning function for your remote control unit.
This remote control unit has the function that can
memorize each remote control code.
TV
POWER
AV
MODE
VIEW
MODE
DISPLAY
1
4
7
0.8 to 2.0 inch (2 to 5 cm)
Remote control
(Supplied accessory)
68
TV CBL VCR DVD
/SAT /LD
/DTV
ANT-A/B INPUT
FRONT
SURROUND MTS CC
TWIN
PICTURE SELECT
SUB TWIN CH
FREEZE INPUT
SLEEP LEARN
EDIT/
2 3
5 6
8 9
0
100
ENT
Remote control of
AV product
Presetting manufacturer codes
1
Slide the Mode switch to match the device
to which you want to preset the remote
control signal.
2
Press EDIT/LEARN and 1 at the same time.
• LED flashes continuously.
3
Press 0 – 9 to enter the manufacturer code.
(See page 69.)
• Preset mode is finished once the LED no longer
lights up.
NOTE
• To stop the EDIT mode in the middle, press EDIT/LEARN
once more.
• If Mode switch is switched while in EDIT mode, EDIT mode
will be canceled.
• If there is no operation for over 1 minute running, exit this
mode.
• When you enter a code that is not listed, LED flashes
quickly.
• If the table on page 69 does not include your desired
manufacturer or the remote control does not work, you
can make the memory learn its signal by the learn mode.
• The initial mode is "00".
Learning the remote control
1
Be sure to slide the Mode switch to match
the device whose remote control signal you
want to be learned.
2
Press EDIT/LEARN and 2 at the same time.
• LED flashes continuously.
3
Press a button for you want to learn.
• Refer to the assigning buttons to functions on
each page.(See page 70 to 75.)
• The LED changes from lit up to flashing state.
• When the learn mode is finished, LED lights
up once and returns to the learn mode (LED
flashes continuously).
4
To exit learn mode, press EDIT/LEARN.
NOTE
• To stop the EDIT mode in the middle, press EDIT/LEARN
once more.
• If Mode switch is switched while in EDIT mode, EDIT mode
will be canceled.
• If there is no operation for over 1 minute running, exit this
mode.
• If TV POWER is pressed over 2 seconds running (LED
flashes continuously, step 2 above), the learning codes
of the current Mode switch position clear, changing back
to preset manufacturer codes. In this case, the LED turns
off after 2 seconds exiting learning mode.