Controller Wiring - Cushman Shuttle 2 Service Manual

ELECTRONIC SPEED CONTROL
Read all of Section B and this section before attempting any procedure. Pay particular attention to Notices, Cautions, Warnings and Dangers.
B
Mount new solenoid and reconnect wiring. Tighten the
solenoid mounting nuts to 67 - 82 in. lbs. (8 - 9 Nm)
torque, the #10 terminal nuts to 13 - 17 in. lbs. (1 - 2
Nm) and the 5/16" terminal nuts to 50 - 60 in. lbs (6 - 7
Nm) torque.
Reconnect the BL- battery cable and replace the seat.
Walkaway
Fuse
Page F-18
#10 Black
Walkaway
From Motor F2
Relay (Power Harness)
J3
J2
Speed Sensor
Harness
Charger Receptacle
Harness
#18 Red/White
RED
From Tow Switch
From Walkaway
(Control Harness)
Fuse
To Ignition Interlock
To Solenoid
(Charger Receptacle)
Fig. 18 Controller Wiring
Repair and Service Manual
PURPLE
From Walkaway Relay
To Solenoid
F2
B+
M-
J1
B-
F1
#4 Black
From Charger
(Charger Harness)
#4 Black
From Battery (-)
(Power Harness
#4 Black
From Motor A1
(Power Harness)
#4 Black
From Motor A1
(Power Harness)
#4 Black
From Motor A2
(Power Harness)
#18 Yellow
From J1 Pin 5
(Control Harness)
#18 Blue
From J1 Pin 17
(Control Harness)
#18 Red
From Tow
Switch and
Reverse Buzzer
(Control Harness)
#10 White
From Charger
Receptacle
Power Harness