Gdl 8X Install Tool; Figure 7-1 Usb-A And Usb-B Connectors; Figure 7-2 Gdl 8X Install Tool Selection Page - Garmin GDL 82 Installation Manual

7.1 GDL 8X Install Tool

The GDL 8X Install Tool provides:
• Diagnostics – reports device, system, and faults information
Configuration – allows selection of installation options
•
System Update – allows upload of software and firmware to the GDL 82 unit
•
GDL 8X Install Tool Requirements:
1. To install the GDL 8x Install Tool, administrative rights may be required.
2. Laptop or PC to run GDL 8X Install Tool. The laptop or PC requirements:
Operating system
Processor speed
Hard drive free memory
RAM memory
®
Winzip (or equivalent application) to extract downloaded file
3. USB-A to USB-B adapter cable to interface between a computer USB-A receptacle and the GDL 82 USB-B
receptacle installed in the wiring harness. The cable length should not exceed 16 ft.
GDL 8X Install Tool Instructions
1. Download the GDL 8X Install Tool from the
2. Connect the USB-A plug on the adapter cable to the computer.
3. With the GDL 82 powered down, connect the USB-B plug on the adapter cable to unit.
4. Apply power to unit.
5. Start the GDL 8X Install Tool on the computer.
6. Select GDL 82.
190-01810-00
Rev. 5
Windows 7 or later
850 MHz
500 MB
256 MB
USB-A

Figure 7-1 USB-A and USB-B Connectors

Dealer Resource Center

Figure 7-2 GDL 8X Install Tool Selection Page

System Configuration
USB-B
and
flyGarmin.com and install.
GDL 82 TSO Installation Manual
Page 7-2