Table of Contents
Advertisement
MISFEED REMOVAL
The copier will stop when a misfeed occurs. The misfeed (
blink.
If paper is accidentally torn during removal, be sure to remove all pieces.
Be careful not to damage the photoconductive drum.
If the misfed paper is seen from this
side, proceed to "C. Misfeed in the
transport area".
If paper is misfed here, proceed to
"A. Misfeed in the paper feed area".
28
) indicator will
Misfeed in the bypass tray
Gently pull the misfed paper out.
1
2
Lift slightly on the side cover and slide the cover out
until it stops. Close the side cover by pressing the
handle on the cover.
The misfeed (
) indicator will go out.
Misfeed in the copier
Open the bypass tray. Lift slightly on the side cover and
1
slide the cover out until it stops.
2
Check the misfeed location. Remove the misfed paper
following the instructions for each location in the
illustration below.
If paper is misfed here, proceed to
"B. Misfeed in the fusing area".
Advertisement
Table of Contents
