Table of Contents
Advertisement
5-5. Finishing the Installation
After finishing insulating and taping over the tubing, use sealing
putty to seal off the hole in the wall to prevent rain and draft
from entering. (Fig. 5-10)
Apply putty here
6. FINAL PROCeDURe
Reinstall the removed part to be placed in its original position.
(See the section "3-2. Preparation Before Installation".)
Then install the accessory supplied side covers (L/R) on both
sides of the indoor unit.
Attach the supplied side plates.
●
Insert the side plates in the direction of the arrow and fix
them with 2 screws once you've removed.
Attach the accessory supplied side covers.
●
Slide the covers from the front side and attach to the claws
of the latches.
Tighten the screws (accessory supplied).
Tubing
Fig. 5-10
Side plate
Screw
Attach
Side cover (accessory supplied)
Screw (accessory supplied)
Fig. 6-1
● Attach the air-intake grille.
When attaching the air-intake grille, perform the reverse
procedure to removing the grille.
Refer to the section "3-2. Preparation Before Installation".
Be sure to attach the safety string.
Close the air-intake grille and fix the claws of the latches with
the screws.
7. HOW TO INSTALL THe TIMeR ReMOTe
CONTROLLeR OR HIGH-SPeC WIReD
ReMOTe CONTROLLeR (OPTIONAL
PART)
N OT E
Refer to the Operating Instructions attached to the optional
Timer Remote Controller or optional High-spec Wired Remote
Controller.
8. HOW TO INSTALL WIReLeSS ReMOTe
CONTROLLeR ReCeIVeR
N OT E
Refer to the Operating Instructions attached to the optional
Wireless Remote Controller Receiver.
17
F616394 18/25
Safety string
Fig. 6-2
Advertisement
Table of Contents
