Fixing System On A Wall Type; Figure 17. Cpe Outdoor Marking Dimensions For Wall Type; Table 7. Tools For Marking - Samsung 310 5G CPE Installation Manual

Fixing System on a Wall Type

A CPE Outdoor can be fixed on wall using a mounting bracket. This section
details the procedures for fixing the mounting bracket on the wall and fixing the
CPE Outdoor on the bracket.
1

Table 7. Tools for Marking

Category
Working Tools
Perform a leveling test before drilling by referring to System Leveling, to ensure
the positions marked are horizontal or vertical. If the result shows the marked
positions are not horizontal or vertical, modify the marking positions.
When the position to place the system is determined, place the system on that
position and then mark the positions where anchor bolts are to be fixed. This
reduces the marking error range.
2

Figure 17. CPE Outdoor Marking Dimensions for Wall Type

5G CPE Outdoor Installation Manual v1.0
Copyright © 2018, All Rights Reserved.
To mark on the wall
Ensure that the items mentioned in the table below are available.
Check the distance between the location for fixing the CPE Outdoor and the
anchor bolt hole, as shown in the figure below.
2.49 (64)
[Rear View]
Chapter 2 Installing System
Description
• Tape Measure
• Permanent Maker
• Level
Unit: in. (mm)
Confidential
: Anchor Bolt Hole
20