Installation - Kenmore 111.77106 Use & Care Manual

Mount the Window Slider Kit
1. Cut a length of foam seal (adhesive
type) to the proper window opening
width and attach it to the window sash.
2. Extend the air exhaust hose to
necessary length. Place the window
slider kit (with flared outlet attached)
onto the window sash.
3. Cut a length of foam seal (adhesive
type) to the proper width and attach it
to the bottom (horizontally hung) or
side (vertically hung) of the window.
4. Close the window securely onto the
window slider kit.
5. Cut the foam seal (non-adhesive type)
to an appropriate length and seal the
open gap at the top of the window
frame.
NOTE: You may use one of the supplied
L brackets to secure the window closed (see
figure to the right). Also, you may use the
two supplied straight brackets to secure the
top side of the slider kit to the window, and
the other two L brackets to secure the
bottom side of the slider kit to the window
frame.
NOTE: The length of the exhaust hose can be extended to 59 inches, but it is
best to keep the length to a minimum. Make sure that the hose does not have
any sharp bends. Do not use extension tubes or replace the supplied exhaust
hose with a different hose, or a malfunction may result. There must be no
obstructions within the hose, or the unit may overheat.
Page 8

INSTALLATION

Foam
Seal
Window Sash
Window
Slider Kit
2 0 . 5 "
- 5 9 "
Window
Slider Kit
Foam
Seal
Foam
Seal
20.5" - 59"
Window
Slider Kit
Window
Slider Kit
Foam
Seal