Installation Instructions - Kenmore 405.84086 Use & Care Manual

INSTALLATION INSTRUCTIONS

LOCATION
The Air Conditioner should be placed on a firm
foundation to minimize noise and vibration. For safe
and secure positioning, place the unit on a smooth,
level floor strong enough to support the unit.
The unit has casters to aid placement, but it should
only be rolled on smooth, flat surfaces. Use caution
when rolling on carpet surfaces. Do not attempt to
roll the unit over objects.
The unit must be placed within reach of a properly
rated grounded socket.
Never place any obstacles around the air inlet or
outlet of the unit.
Allow at least 12'' of space from the wall
for maximum performance.
WINDOW SLIDER INSTALLATION
Your window slider has been designed to fit
most standard vertical and horizontal window
applications. However, it may be necessary
for you to modify some aspects of the installation
procedures for certain types of windows. Refer to
Fig. 6 and Fig. 7 for minimum and maximum
window openings.
Once your window slider is opened to the correct
width, insert the supplied screw to secure the
window in place(see Fig. 7a).
NOTE: If the window opening is less than the
minimum length of the window slider, only use
the window slider section with the hole. Cut from
the end that is furthest from the section hole.
Do not cut any material from the end that is
nearest hole.
Vertical
Window
Window Slider
Minimum:26.57 Inch(67.5cm)
Maximum: 48.43Inch(123cm)
Vertical
Window
Window Slider
Minimum:26.57 Inch(67.5cm)
Maximum: 48.43Inch(123cm)
Bolt
8
Fig.6
Fig.7
Window slider sections
Fig.7a