Check The Field Strength; Your First Call - Sagem RT30F - PCS Basic Manual

INSTALLING AND USING THE TERMINAL FOR THE
FIRST TIME

Check the field strength

The upper lamp on the terminal will flash rapidly if the field strength is incorrect or if
there is no connection to the phone network.
If necessary, connect an external antenna to the device. Move the external antenna to a
position where the coverage is at its maximum.
The external antenna should preferably be inside building to avoid overvoltages due to
lightning. If not, it is the responsability of installer to provide adequate overvoltage
protections on external antenna. The installation must be done by qualified personal.

Your first call

Note: In case of a problem at any step of the operations, you can re-initialize the
device and disconnecting the battery, wait for 1 minute and connect it again.
This operation should only be done by the qualified personnel.
Making your first call
1. Lift the handset; il you hear a 2 bip/second tone in the handset, enter your PIN
code and validate using #. This action is only done when you use your terminal
for the first time. You should hear a continuous dialling tone inviting you to dial
and the lower lamp on your terminal should be blinking.
2. You can then proceed as if you were using a conventional fixed phone.
3. When you replace the handset, the lower lamp stops blinking.
Receiving calls
1. When you receive a call, your phone rings (activation by the terminal).
2. When you lift the handset, the lower lamp blinks slowly.
3. You can speak to the caller.
Your first call 17