Before Connecting, Real Carefully Safety Instructions P3; Commissioning - Sagem RT30F - PCS Basic Manual

INSTALLING AND USING THE TERMINAL FOR THE
FIRST TIME
Before connecting, read carefully safety instructions p3
Line
1. Connect your phone set to the other end of your phone cord.
2. Plug the phone cord into the RJ11connector J3
Power supply
1. Plug the power supply cable to the connector J4
2. Plug the other end of the power supply cable into a 230 V electrical socket outlet.

Commissioning

After having powered the terminal, you will see the lamps successively blinking as below
(it generally takes less than 1 minute, depending on network):
1. Both lamps on the front panel of the terminal flash alternatively to indicate that the
terminal is initializing.
2. At the end of initialization, both upper and lower lamps flash rapidly during
1 second.
3. If necessary, enter you PIN code as indicated in paragraph Your first call p13.
4. The lower lamp is on, meaning the terminal is ready to use.
16
J1 J2
Your terminal is now installed !
Check the signal strength.
You can now make your first calls !
.
.
J3 J4 J5
Installing your terminal