Installing Your Terminal - Sagem RT30F - PCS Basic Manual

INSTALLING AND USING THE TERMINAL FOR THE
FIRST TIME

Installing your terminal

Where should you install your terminal?
In order to prevent any interference between your terminal and other electrical
equipment in the immediate vicinity (phones, television sets, microcomputers, etc.),
which could result in extraneous noise, make sure that you install your terminal at a
distance of at least 2 m from any of these types of equipment.
However, if there is no sign of any interference, you can reduce this distance.
Distance between your phone and the terminal
Make sure that, when your phone is connected to the terminal, the distance
between them is at least 2 m. If you become aware of interference, move the phone
and its cord further away from the terminal, until the interference disappears.
Wall installation
Required tools
• One hammer drill + set of drills
• One 500 mm spirit level
• One flat blade screwdriver
• One 2-meter tape measure.
Procedure:
1. Mark out the positions of the fixing holes, either using the drilling template (part of
the packaging: cut it) or by marking two points 145 mm apart in a vertical line.
Vertical attachment 300 mm from the ground (terminal low point) (see Figure on
opposite page).
2. Check the vertical alignment of the points using the spirit level.
3. Drill to a diameter of 5 mm and a depth of 25 mm.
Installing your terminal
25
ÿ 5
13