Adjusting The Signal Of The Sound Source - Sennheiser RS 145 comfort Instruction Manual

Set the channel selector switch
transmitter to channel 1, 2 or 3.
To set the headphones to the selected channel:
Press the TUNE button

Adjusting the signal of the sound source

The transmitter automatically ensures that the headphones
always receive an optimum signal. However, the signal of the
sound source can be so weak or so strong that it can no longer
be automatically adjusted.
Signal of the sound source is too weak
If the signal of the sound source is too weak, the indicator for
speech intelligibility and sound signal
Gradually increase the volume of your sound source until
the flashing stops.
If the signal of the sound source is too weak, an
optimum transmission is not possible. It could be that
the transmitter switches off after some time. Please
refer to the chapter "If a problem occurs ..." on page 19.
Signal of the sound source is too strong
If the signal of the sound source is too strong, the indicator for
speech intelligibility and sound signal
Gradually reduce the volume of your sound source until the
flashing stops.
Using the RS 145 comfort system
B
on the
3
on the headphones.
0
0
flashes slowly.
flashes rapidly.
15