Using The System Components; Switching The Transmitter On; Switching The Stehoset Receiver On - Sennheiser IS410 Instructions For Use Manual

Using the system components

Switching the transmitter on

Take the stethoset receiver out of the transmitter's charging
compartment
The LED lights up green.
Note:
If the receiver is placed into the transmitter's charging
compartment
The LED goes off.

Switching the stehoset receiver on

Volume up? - No!
Attention!
When people use headphones, they tend to
choose a higher volume than with loudspeakers.
Listening at high volume levels for long periods
can lead to permanent hearing defects. Please
protect your hearing, Sennheiser headphones also
sound exceptionally good at low volumes.
The stethoset receiver automatically switches on when you pull
the earbows apart and put the receiver on. When you take the
receiver off, it automatically switches off.
Before putting the receiver on, use the volume control
adjust the volume to a low level. This protects your hearing
from damage.
Put the receiver on the correct way round, with the
Sennheiser logo at the front.
. The transmitter automatically switches on.
, the transmitter automatically switches off.
to
9