Scope; Preface; Site Survey - Honeywell STDW810 Professional Installation Manual

1. Designation, Scope and Preface

1.2. Scope

1.2 Scope
This document outlines professional installation requirements for the Honeywell SmartLine
Wireless Transmitter for the Honeywell OneWireless Network. Professional installation is
required to comply with certification agency and legal requirements. This document must be
adhered to for all installations of the Honeywell OneWireless SmartLine Wireless Transmitters.

1.3 Preface

This manual covers professional installation of the Honeywell OneWireless SmartLine Wireless
Transmitters. See the Getting Started with Honeywell OneWireless, Honeywell OneWireless
Planning Guide and Honeywell OneWireless SmartLine Wireless User's Guides for general
information on overall system implementation, configuration, and management of these devices.
The SmartLine Wireless is classified by the FCC as a device that must be professionally
installed. To be in compliance with FCC requirements, the transmitter must be installed with one
of the approved antennas listed in this document.

1.4 Site survey

It is assumed for the purposes of this document that a site survey has been performed and that the
antenna types, cable lengths and lightning surge arrestors were appropriately selected per the
results of that survey. Any changes to these items as a result of the actual installation of the
SmartLine Wireless transmitters into the site may require that the TX power setting of the radio
board needs to be adjusted from the factory setting in order to maintain agency approvals. See
Section 0 and Section 8
2
for more information.
SmartLine Wireless Transmitter Professional Installation Guide Revision 1