Technical Support - Siemens SITRANS F M MAG 5000 Operating Instructions Manual

Service and maintenance

9.2 Technical support

Power on transmitter
1.2.1
1.2.2
2
2.1
2.1.1
2.1.2
Note
Sensor check list
Check list for sensors are included in the respective sensor operating instructions.
9.2 Technical support
NOTICE
Repair and service must be carried out by approved Siemens Flow Instruments personnel
only.
Note
Siemens Flow Instrument defines sensors as non-repairable products.
Technical Support
If you have any technical questions about the device described in these Operating
Instructions and do not find the right answers, you can contact Technical Support:
● Via the Internet using the Support Request:
● Phone: +49 (0) 180 5050 222
Further information about our technical support is available in the Internet at
Technical support (http://support.automation.siemens.com/WW/view/en/16604318)
58
Transmitter OK
Check cables/conndections
Check connection board
Check pins in transmitter multiplug
Check cables/conndections
Check connection board
Check pins in transmitter multiplug
Output readings OK?
Dispaly defective
Transmitter defective
Support request (http://www.siemens.com/automation/support-request)
Check application
Check installation/sensor/earthing
connection etc.
OK ⇒ 1.2.1
Not OK ⇒ correct fault
OK ⇒ 2.1
Not OK ⇒ Correct fault
Yes ⇒ 2.1.1
No ⇒ 2.1.2.
Replace display
Replace transmitter
SITRANS F M MAG 5000/6000
Operating Instructions, 12/2013, A5E02338368-002