Changing Operator Menu Setup - Siemens SITRANS F M MAG 5000 Operating Instructions Manual

Changing decimal point position
1. Enter the respective totalizer menu.
2. Use select key
3. Use change key
Changing units
1. Use select key
2. Press change key
6.6

Changing operator menu setup

In the operator menu the menus required for daily operation of the flowmeter are shown. It is
possible to hide and change some of the menus in the operator menu. This is done in the
operator menu setup menu, see operator menu setup diagram.
Customizing menus in operator menu
To customize the menus in the operator menu perform the following steps:
1. Press top up key
2. Enter password.
3. Use forward key
Changing text in line 1
1. Press lock/unlock key
2. Use change key
3. Press lock/unlock key
Enabling two readings
1. Use forward key
2. Press lock/unlock key
3. Use select key
4. Use change key
5. Press lock/unlock key
SITRANS F M MAG 5000/6000
Operating Instructions, 12/2013, A5E02338368-002
to position cursor below decimal point.
to move decimal point to requested position.
to position cursor below unit.
until requested unit is displayed.
for 2 sec.
or backward key
to select desired text.
Note
If "Text" is selected in line 2, this line functions as a heading for the value shown in line 3.
Otherwise it shows the actual value of the reading selected.
to reach requested menu.
to move cursor to upper line.
to select requested reading.
to reach operator menu.
to unlock setting.
to confirm selected text.
to unlock setting.
to confirm selection.
Commissioning
6.6 Changing operator menu setup
45