March 15, 2001
IBM-3345 (REV : 0.1)
OPERATION - continued
Figure 13
SETTING THE AREA CODE
Push ' CALLBACK' button at Stand -By mode, then ' SET AREA CODE' appears in the LCD display.
£ - £ - £ -
Press you local area code-3 digits using the dial key pad buttons.
When you finish setting your local area code, press the CALLBACK button.
If you want to delete area code, press "Redial-Pause" button
The LCD display will go to Stand-By Screen mode as shown below.
IBM-3345 is now ready to receive incoming calls.
The display will disappear after 15 seconds to save battery automatically
17