Cannot Connect To The Extender; Cannot Join A Wifi Network And Receive An Error Message - NETGEAR EX7000 User Manual

Cannot Connect to the Extender

If you cannot connect to the extender, determine what prevents you from connecting:
• If you forgot your user name or password, click the Username & Password Help link.
For more information, see
• If your browser displays an error page, include http:// in the address field of your browser
by typing http://www.mywifiext.net.
• If you already set up the extender but can no longer connect to it over WiFi, check to see
if the Link Rate LED is off or red.
• If you cannot get a WiFi connection working, you can use an Ethernet cable to connect
your computer to the extender.

Cannot Join a WiFi Network and Receive an Error Message

To join a WiFi network, you must know its network name (also called the SSID) so that you
can select it. If the network is secure, you must know the passphrase or key. If the extender
does not connect to the network that you select, the cause might be one of the following:
• It is possible that you typed the network name, passphrase, or key incorrectly. Use Smart
Setup (see Run Smart Setup Installation
the passphrase or key. The passphrase or key is case-sensitive. For example,
PASSWORD25 is not the same as Password25 or password25.
• If the extender cannot detect your WiFi network, check to see if your WiFi network is still
working. Make sure that the WiFi router is turned on. If possible, move the extender
closer to the WiFi router.
• If the extender Link Rate LED is red, the WiFi connection between the WiFi router and the
extender is poor. You can establish the best connection with a clear line of sight between
the extender and the WiFi router. Make sure that no physical obstacles exist between the
extender and the WiFi router, and try to move the extender closer to the WiFi router.
If you use Smart Setup, and the extender does not connect to the WiFi router, does not
connect to the Internet, or cannot get an IP address from the WiFi router, Smart Setup
displays a message to notify you that the extender is not configured.
To run Smart Setup again, click the YES button. To manually configure the extender, click the
NO, CONFIGURE MANUALLY button.
AC1900 Nighthawk WiF Mesh Extender
FAQs on page 65.
on page 20) to select a WiFi network and retype
FAQs and Troubleshooting
70