Table of Contents
Advertisement
4.1 Installation procedure of SWL-2100N PCMCIA Card
Important: Do not insert the PCMCIA card until you are asked to do so, failure of
which may result in unsuccessful installation of your PCMCIA card.
Important: Some notebook computers for Win NT 4.0 operating system that do not
support 3.3V cards will not install your PCMCIA card successfully. You are advised to
install the driver for PCMCIA Controller available from set manufactures or install the
CardWizard
program that will enable the notebook computers supporting 5.0V cards to
support 3.3V cards also and will install your PCMCIA card successfully.
Please follow the following steps one by one to install the PCMCIA card successfully.
There are two cases: one is when there is no Windows NT networking Installed and the other
is when the Windows NT networking is installed.
When Windows NT networking is not installed yet:
1. Power on your PC and allow the Windows NT to load fully.
2. Now insert the Installation CD. Select the software Installation and click on Install.
3. When there is no Windows NT networking installed yet. You should install your
driver manually. To do so, click on start in task bar, go to Settings and then to
Control Panel.
4. Under Control Panel, double click on Network icon.
5. Since there is no Windows NT networking installed yet, you will be asked if you
want to install NT networking first. Click on Next and then you will be asked how
will you access the network: modem or LAN. Check the proper selection and click on
next. In network setup wizard box, click on select from list button.
6. In Select Network Adapter box click on Have Disk button.
7. In Insert Disk box, you may be asked to specify the necessary software directory.
Insert the MagicLAN Installation CD into the CD-ROM drive. Type in D:\nt40
(Where D is the CD-drive of your Notebook) in the blank and click on OK.
8. In Select OEM Option box, we will see Samsung 11Mbps W ireless LAN Card
and click on OK.
9. We confirm the Samsung 11Mbps Wireless LAN Card.
10. Select the network protocols by clicking on the Protocols. And click on TCP/IP.
11. In the next box to choose network services to use, make sure that all the services you
want to use are checked and click on Next.
12. In the next box it is confirmed that necessary NT networking components are selected.
15
Advertisement
Table of Contents
