Table of Contents
Advertisement
Access Easy Controller 2.1
To Clock In
Press the key of the Entry Reader and present your card. The LED will flash once and the door
will be unlocked if the cardholder has been given the access right.
To Clock Out
Press the key of the Entry Reader and present your card. The LED will flash once. The door
remains locked.
If presenting card without pressing any one of these two keys, the reader will resume normal
door access operation. There will not be any Clock In or Clock Out transactions.
12.2.4
Changing PIN Code
The PIN code can be changed by first activating the or
General steps to change the PIN code.
1.
2.
3.
4.
5.
For example, suppose you want to change an old PIN code (8088000) to a new PIN code
(4321).
1.
2.
3.
4.
5.
Notice!
The number of digits for the User PIN code range from 1 to 7 digits. Refer to the AEC2.1
Software user manual chapter on Card Administration > Card Functionality for further details.
12.2.5
Entry and Arm/Disarm Reader
A Reader can be configured to allow arming or disarming a group of Input Points (collectively
called an Alarm Zone), using methods similar to Door Access such as, Manual Card Number
entry, Card only, Card + PIN code and common Reader's PIN code (refer to the previous
section for detail).
Cardholders can arm/disarm the Alarm Zone and this setting is configured under the section
Card Administration, Card Functionality.
The statuses of the Alarm Zone are indicated via the LED.
Robert Bosch (SEA) Pte Ltd
Press the or
key.
Present Card - LED will flash at a slow rate.
Enter the old PIN code - LED will flash at medium rate.
Enter the new PIN code - LED will stop flashing.
Press
or
key (PIN code change is completed).
First, press or
key.
Present your card to the Reader. The LED will start to flash continuously at a slow rate for
the duration as depicted in the Keypad Time-out field.
Enter the old PIN code , the LED will flash continuously at medium rate. However, if the
entered PIN is wrong, the LED will flash continuously at a fast rate. In this case, press
or
and repeat from step 1.
Enter the new PIN code , followed by
Press the
or
key to complete the process.
Hardware Installation Manual
Card Reader Keypad Functions | en
key before presenting the card.
or
key.
2018.11 | 1.0.6 | F.01U.122.796
65
Advertisement
Table of Contents
