Rigging And Moving - Yazaki AROACE Installation Instructions Manual

RIGGING AND MOVING

The Yazaki chiller is designed for
overhead rigging with lifting lugs provided
from the factory.
When rigging for overhead lift, attach
shackle bolts to the lifting lugs. Bring the
four individual rigging cables
together at a point high
1m minimum)
enough that the angle between the
rigging line and the top of the unit is no
less than 60°, as shown in the drawing
below.
Figure 4 – Rigging
Clearance
A - Vertical
B - Passageway
C - Into Corner
D - Out of Corner
Table 3 – Hallway Clearances
(each 40" or
Inches
(mm)
88
(2235)
55
(1400)
55
(1400)
55
(1400)
7
There are times when the unit simply
cannot be moved to the final installation
site while remaining in the vertical
position. It is be permissible to lay the
unit on its side, so long as the proper
precautions and guidelines are followed.
1. Transport by vehicle ONLY with the
unit in vertical
THERE IS NO
Transport by vehicle over roadway
while the unit is not in the vertical
configuration will void the warranty.
2. The unit may ONLY lay over onto its
back - the side with the water
connections. It may NOT lay over on
any other side!
a. While on its back, the water piping acts
as legs to support the internal tubing
bundles. On any other side, the tubing
bundles will not be properly supported
and may shift or become severely
damaged, rendering
inoperable.
3. Do not simply tip the unit over onto its
back. It should be lifted and turned to
the horizontal configuration while fully
supported and suspended, though it
only need be 1"
ground while turning.
4. DO NOT lay the unit directly onto the
ground in a manner in which the water
connections support the weight of the
unit. Attach 4x4 blocks or timbers to
the frame for support in the horizontal
configuration.
5. DO NOT USE
LIFTING when laying the unit onto its
side. At least THREE lifting points will
be necessary.
configuration.
ALTERNATIVE.
the machine
or so off the
(25mm)
SINGLE POINT