Touchscreen calibration
Ú Note:
Ensure the screen is clean and dry before doing the
calibration. Do not touch the screen unless prompted to do so.
In some cases it may be required to re-calibrate the touch screen. To
re-calibrate your touchscreen, do the following:
1.
Turn the unit off
2.
Press and hold the waypoint key, and turn the unit on
3.
Continue pressing the waypoint key during power on until the
calibration utility screen comes up
4.
Follow the instructions on the screen to perform the calibration.
When completed, the unit returns to the application screen.
The settings dialog
The software setup is done from the settings dialog.
System settings
Boat settings
Used to specify the physical attributes of the boat.
Software setup
| ELITE Ti² Installation Manual
27