Craftsman 113.2433 Owner's Manual page 29

CRAFTSMAN 12-iNCH BAND SAW/SANDER, MODEL 113.243300 & 113.243311
NOTE:
ANY ATTEMPT TO REPAIR THIS MOTOR
MAY CREATE A HAZARD UNLESS
REPAIR IS DONE BY QUALIFIED
SERVICE TECHNICIAN.
REPAIR SERVICE IS AVAILABLE
AT YOUR NEAREST SEARS STORE.
\
@-
3
\
\
FIGURE 4-- MOTOR PART NO. 69183
SUPPLIED WiTH MODEL 113.243311 ONLY
Key Part
No. No.
60306
64088
64258
Description
Screw, 8-32 x 3/8, Thread
Cutting, Slotted, Serrated
Hd.
Cover, Terminal
Cord with Plug
MOTOR CONNECTIONS
WARNING: FOR YOUR OWN SAFETY, NEVER
CONNECT PLUG TO POWER SOURCE OUTLET UNTIL
ALL ASSEMBLY STEPS ARE COMPLETED.
1. Open motor connector box cover located on left end of
motor (viewed from rear of saw) using a flat blade
screwdriver.
2. Remove GREEN SCREW and Iockwasher and insert
screw through round metal terminal on the end of the
GREEN wire of power cord with tockwasher between
terminal and motor frame. (See illus.)
3. Reinsert GREEN SCREW in the threaded hole. Tighten
securely.
4. Insert terminal end of WHITE wire on spade terminal
marked T4 on the motor. Push terminal firmly until
seated.
5. Insert terminal end of BLACK wire on spade terminal
marked T1 on the motor. Push terminal firmly until
seated.
6. Close motor connector box being sure that power cord is
seated in the largest strain relief groove, and tighten box
cover screws.
GREEN
iNTERNAL'
LOCKWASHER
TERMINAL
GREEN WIRE
-TO GREEN SCREW
STRAIN RELIEF
pOVE
TO
TERMINAL T4
29