Figure 4-4. Removing the Access Cover to the System Boards
Installing the Access Cover to the System Boards
To install the access cover:
1. Observe the safety and ESD precautions listed at the beginning of this
chapter.
2. Position the access cover with the captive screws toward the front of the
server.
3. Insert the tabs on the rear of the cover into the slots at the rear of the chassis.
4. Press down gently and tighten the captive screws at the front of the cover.
5. Install the rear access cover following procedures previously described in
this chapter.
Removing the Memory Board
To remove the memory board:
1. Observe the safety and ESD precautions listed at the beginning of this
chapter.
2. Power off the system. Ensure the power cords are unplugged from the AC
wall outlet.
3. Remove the rear access cover and system board access cover following
procedures previously described in this chapter.
4. Grasp the bracket on the top edge of the memory board and pull outwards
until the board disengages from the connector on the processor board
(Figure 4-5).
5. Lift the memory board out of the chassis.
Upgrading Your System 4-9